kolibrios/programs/network/netsurf/libhubbub/docs/Macros

61 lines
2.8 KiB
Plaintext
Raw Normal View History

The data which Hubbub is fed (the input stream) gets buffered into a UTF-8
buffer. This buffer only holds a subset of the input stream at any given time.
To avoid unnecessary copying (which is both a speed and memory loss), Hubbub
tries to make all emitted strings point into this buffer, which is then
advanced after tokens have been emitted. This is not always possible, however,
because HTML5 specifies behaviour which requires changing various characters to
various other characters, and these sets of characters may not have the same
length. These cases are:
- CR handling -- CRLFs and CRs are converted to LFs
- tag and attribute names are lowercased
- entities are allowed in attribute names
- NUL bytes must be turned into U+FFFD REPLACEMENT CHARACTER
When collecting the strings it will emit, Hubbub starts by assuming that no
transformations on the input stream will be required. However, if it hits one
of the above cases, then it copies all of the collected characters into a buffer
and switches to using that instead. This means that every time a character is
collected and it is possible that that character could be collected into a
buffer, the code must check if it should be collected into a buffer. To allow
this check, and others, to happen when necessary and never otherwise, Hubbub
uses a set of macros to collect characters, detailed below.
Hubbub strings are (beginning,length) pairs. This means that once the
beginning is set to a position in the input stream, the string can collect
further character runs in the stream simply by adding to the length part. This
makes extending strings very efficient.
| COLLECT(hubbub_string str, uintptr_t cptr, size_t length)
This collects the character pointed to "cptr" (of size "length") into "str",
whether str is a buffered or unbuffered string, but only if "str" already
points to collected characters.
| COLLECT_NOBUF(hubbub_string str, size_t length)
This collects "length" bytes into "str", but only if "str" already points to
collected characters. (There is no need to pass the character, since this
just increases the length of the string.)
| COLLECT_MS(hubbub_string str, uintptr_t cptr, size_t length)
If "str" is currently zero-length, this acts like START(str, cptr, length).
Otherwise, it just acts like COLLECT(str, cptr, length).
| START(hubbub_string str, uintptr_t cptr, size_t length)
This sets the string "str"'s start to "cptr" and its length to "length".
| START_BUF(hubbub_string str, uintptr_t cptr, size_t length)
This buffers the character of length "length" pointed to by "c" and then
sets "str" to point to it.
| SWITCH(hubbub_string str)
This switches the string "str" from unbuffered to buffered; it copies all
characters currently collected in "str" to the buffer and then updates it
to point there.