kolibrios-gitea/programs/develop/libraries/menuetlibc/include/net/if_ether.h

81 lines
3.2 KiB
C
Raw Normal View History

#ifndef _NET_IF_ETHER_H
#define _NET_IF_ETHER_H
#include <sys/cdefs.h>
__BEGIN_DECLS
/* taken from <linux/if_ether.h> */
#define ETH_ALEN 6 /* Octets in one ethernet addr */
#define ETH_HLEN 14 /* Total octets in header. */
#define ETH_ZLEN 60 /* Min. octets in frame sans FCS */
#define ETH_DATA_LEN 1500 /* Max. octets in payload */
#define ETH_FRAME_LEN 1514 /* Max. octets in frame sans FCS */
/*
* These are the defined Ethernet Protocol ID's.
*/
#define ETH_P_LOOP 0x0060 /* Ethernet Loopback packet */
#define ETH_P_PUP 0x0200 /* Xerox PUP packet */
#define ETH_P_PUPAT 0x0201 /* Xerox PUP Addr Trans packet */
#define ETH_P_IP 0x0800 /* Internet Protocol packet */
#define ETH_P_X25 0x0805 /* CCITT X.25 */
#define ETH_P_ARP 0x0806 /* Address Resolution packet */
#define ETH_P_BPQ 0x08FF /* G8BPQ AX.25 Ethernet Packet [ NOT AN OFFICIALLY REGISTERED ID ] */
#define ETH_P_IEEEPUP 0x0a00 /* Xerox IEEE802.3 PUP packet */
#define ETH_P_IEEEPUPAT 0x0a01 /* Xerox IEEE802.3 PUP Addr Trans packet */
#define ETH_P_DEC 0x6000 /* DEC Assigned proto */
#define ETH_P_DNA_DL 0x6001 /* DEC DNA Dump/Load */
#define ETH_P_DNA_RC 0x6002 /* DEC DNA Remote Console */
#define ETH_P_DNA_RT 0x6003 /* DEC DNA Routing */
#define ETH_P_LAT 0x6004 /* DEC LAT */
#define ETH_P_DIAG 0x6005 /* DEC Diagnostics */
#define ETH_P_CUST 0x6006 /* DEC Customer use */
#define ETH_P_SCA 0x6007 /* DEC Systems Comms Arch */
#define ETH_P_RARP 0x8035 /* Reverse Addr Res packet */
#define ETH_P_ATALK 0x809B /* Appletalk DDP */
#define ETH_P_AARP 0x80F3 /* Appletalk AARP */
#define ETH_P_8021Q 0x8100 /* 802.1Q VLAN Extended Header */
#define ETH_P_IPX 0x8137 /* IPX over DIX */
#define ETH_P_IPV6 0x86DD /* IPv6 over bluebook */
#define ETH_P_PPP_DISC 0x8863 /* PPPoE discovery messages */
#define ETH_P_PPP_SES 0x8864 /* PPPoE session messages */
#define ETH_P_ATMMPOA 0x884c /* MultiProtocol Over ATM */
#define ETH_P_ATMFATE 0x8884 /* Frame-based ATM Transport over Ethernet */
/*
* Non DIX types. Won't clash for 1500 types.
*/
#define ETH_P_802_3 0x0001 /* Dummy type for 802.3 frames */
#define ETH_P_AX25 0x0002 /* Dummy protocol id for AX.25 */
#define ETH_P_ALL 0x0003 /* Every packet (be careful!!!) */
#define ETH_P_802_2 0x0004 /* 802.2 frames */
#define ETH_P_SNAP 0x0005 /* Internal only */
#define ETH_P_DDCMP 0x0006 /* DEC DDCMP: Internal only */
#define ETH_P_WAN_PPP 0x0007 /* Dummy type for WAN PPP frames*/
#define ETH_P_PPP_MP 0x0008 /* Dummy type for PPP MP frames */
#define ETH_P_LOCALTALK 0x0009 /* Localtalk pseudo type */
#define ETH_P_PPPTALK 0x0010 /* Dummy type for Atalk over PPP*/
#define ETH_P_TR_802_2 0x0011 /* 802.2 frames */
#define ETH_P_MOBITEX 0x0015 /* Mobitex (kaz@cafe.net) */
#define ETH_P_CONTROL 0x0016 /* Card specific control frames */
#define ETH_P_IRDA 0x0017 /* Linux-IrDA */
#define ETH_P_ECONET 0x0018 /* Acorn Econet */
/*
* This is an Ethernet frame header.
*/
struct ethhdr {
unsigned char h_dest[ETH_ALEN]; /* destination eth addr */
unsigned char h_source[ETH_ALEN]; /* source ether addr */
unsigned short h_proto; /* packet type ID field */
};
__END_DECLS
#endif